|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great product, helped me to restore vintage walkman cassette.
Just some pictures could be little bit more sharp and contrast
Thank you
;
I love older radio's and the service manuals that are sometimes hard to find. Was able to find a manual quite easily on this site.
;
Thank you for your shop manual! Your help was very useful - the device is repaired! Once again - Thank you! I wish you a successful business! Edward (Russia).
;
It was a great experience,instead of purchasing a new Stereo Amplifier ,in just minutes i repaired my old one and that was thaks to the manual I have purchased from you.
Thanks again.
Samuel Alter
;
Das ging ja sehr unkompliziert hat bestens geklappt und die Quallität ist auch noch gut.
Vielen Dank dafür.
Section 3 Replacement of Mechanical Part
3-1. Fan Motor Replacement
Note Adjustment after the fan motor replacement is not required. Preparation 1. Turn the power off. 2. Remove the ornamental panel. (Refer to Section 1-1.) Removal 1. Disconnect the Connectors (1) Release the harness clamper on the HN-206 board. (2) Disconnect the connector CN212 on the HN206 board. 2. Remove the Fan Motor Remove the four screws, then remove the fan motor.
Fan motor Rear panel Brackets
Screw (B3 X 30)
HN-206 board
Installation 3. Install the Fan Motor (1) Set the new fan motor as shown in the figure. And align the screw holes in the two brackets with the screw holes in the fan motor. (2) Install the fan motor on the rear panel in the state of step (1). 4. Connect the Connectors (1) Connect the connector into CN212 on the HN-206 board. (2) Fix the harness by the harness clamper on the HN-206 board keeping the harness from contact with the fan motor.
Screw (B3 X 30)
Harness clamper
HN-206 board
CN212
Remove/Install the Fan Motor
3-1
|
|
|
> |
|
