|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
3-6. Drum Exit Side Block
4. Remove the Yoke Plate Remove the screw, then remove the yoke plate from the T tension arm. Installation 5. Install the Yoke Plate (1) Install the yoke plate to the T tension arm as shown in the figure, then tighten the screw. (2) Apply locking compound to the screw.
Screw (B2 X 5)
T tension arm
Yoke plate Apply locking compound
White paint
Remove/Install the Yoke Plate
6. Install the T Tension Arm (1) Clean the shaft with a cleaning cloth moistened with cleaning fluid. (2) Insert the bearing into the hole of the T tension arm. (3) Hook the two tension springs to the T tension arm as shown in the figure. (4) Pass the T tension arm through the shaft while putting DME on the TR-79 board into the T tension arm. (5) Fix the T tension arm by the stop washer.
T tension arm
Stop washer Bearing
Springs
Shaft (Cleaning) DME
TR-79 board
Install the T Tension Arm
3-113
|
|
|
> |
|
