WHIRLPOOL ADP9...
Owner's Manual

MAINTENANCE AND CLEANING
Before cleaning or carrying out maintenance, press the ON/OFF button. 1. Clean the appliance exterior with a neutral detergent. Do not use abrasive detergents. 2. Regularly wipe the door seal and inside of the door with a damp cloth to remove any food residues. If the spray nozzles become clogged with food residues, clean the spray arms as follows. Upper spray arm: � Slacken the fixing nut (by turning it counter-clockwise) A and detach the spray arm by pulling it down B. � Rinse the nozzles. � Remount the spray arm by aligning it with the rotary mounting and insert it. � Tighten the fixing nut by turning it clockwise. Make sure the nut is fully tightened (it should click). Make sure the spray arm rotates freely. Lower spray arm: � Press the two levers inwards which fix the spray arm A and detach by pulling it up B. � Rinse the nozzles. � Remount the spray arm by aligning it with the rotor pin and insert it. � Push the spray arm down until it is fixed in place. � Make sure the two levers are correctly inserted (they should click). Make sure the spray arm rotates freely. Cleaning the filters 1. Fully unscrew the wide-mesh central filter by turning it counter-clockwise and extract it A. 2. Fully unscrew the cylindrical filter and extract it from the wide-mesh central filter B (pay due attention to the holes in the bottom of the filter). 3. Remove the fine-mesh filter C. 4. Clean all the components. 5. Reassemble: Insert the cylindrical filter in the wide-mesh central filter. Fit the fine-mesh filter and screw down the filter unit by turning it clockwise. The filter unit must be correctly assembled to ensure good washing results.
A B

C

20