|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great Manual. This manual is available no where else. It was exactly what I was looking for. Only in German.
 ;
This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
 ;
The owner's manual was evetything I thought it would be. I was able to print it out using both sides of the paper in quick order, saving me a search online for a used one.
 ;
Хорошее качество сканирования.
Мануал пришел часов эдак через 12. В целом доволен.
 ;
Fantastic quality and impressive delivery time. Based on this manual, I recommend this service without hesitation! Five Stars for certain.
30302005GB.fm Page 8 Tuesday, March 14, 2006 3:09 PM
Removing the baskets
� Pull the baskets out fully, then lift them up slightly in order to remove. Drawers (except the bottom drawer), runners and the white grid (if provided) may be removed in order to obtain increased storage space (Fig.1) Ensure that the load does not exceed the limit (if present) indicated on the side walls of the appliance. Fig. 1
Compartment
Use this compartment only for making ice cubes and storing ice packs, as shown in Fig. 2 and 3 (if supplied). Always observe the storage times given on frozen food packaging.
Making ice cubes
� Fill the ice cube tray 2/3 full and place it in the special freezer compartment. � Do not use sharp or pointed instruments to detach the tray if it is stuck to the bottom of the freezer. � Bend the ice tray slightly to remove the cubes. Note: The freezer door will not re-open easily immediately after closing (except for models featuring a special valve). Wait a few minutes before opening again in order to allow for compensation of the vacuum created.
Fig. 2
Fig. 3
8
|
|
 |
> |
|