|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
;
SCANNING OF HIGH QUALITY
VERY, VERY HIGH VELOCITY DOWNLOAD
VERY GOOD PRICE,
TRUE SATISFIED, THANKS
;
Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
;
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
Operation
User Setup
AFS 224 Filter Q's
+3 +2
Music High - 1/80th Octave
AFS 224
+3 +2 +1 -0 -1
Music Med - 1/20th Octave
+1 -0 -1 -2 d B -3 u -4 -5 -6 -7 -8 -9 700 750 820 850 900 .95k 1k Hz 1.2k
-2
Music Low - 1/10th Octave
d -3 B u -4 -5 -6 -7 -8 -9
Speech - 1/5th Octave
Live Filter Lift: Live Filter Lift provides maximum sonic integrity by removing unnecessary feedback filters. This button is used to select the live filter lift times and are indicated as follows: LED Lift Time Not Lit Lift Off Green 10 Seconds Yellow 10 Minutes Red 60 Minutes Mode: This button is used to select FIXED (button is green) or LIVE (button is red). The Mode button is also used to set the number of filters. For more information please see Section B Set Up AFS Filter LEDs: The AFS 224 offers 24 filter LEDs per channel, which are used to indicate the number of fixed and set filters within each channel.
User Setup
This section of the manual is provided to give the user step-by-step instructions for setting up and optimizing the performance of the AFS 224.
A - Setting Gain Structure
The four basic ways to hookup the AFS 224 to your system are as follows: 1) 2) 3) 4) Connected to the insert jack(s) on a microphone channel of a mixer. Connected to the insert jack(s) on the main outputs of a mixer. Connected to the subgroup insert jack(s) of a mixer. Connected inline w/outputs of a mixer (output of mixer to input of 224, output of 224 to amplifiers).
For maximum performance and proper operation, the average input signal should consistently light the 0 dBu LED, with the +10 dBu LED occasionally lighting. Hookup methods 1, 2 & 3 above are the preferred way to connect the AFS 224 since the insert points on most mixers are pre output fader. This allows the proper signal level to be fed to the AFS 224 without the channel or output fader affecting the level as the fader is moved up or down. Be sure to check the mixer�s manual for the nominal operating point for the insert jacks, and then select the +4dBu or -10dBV switch on the back of the AFS 224 accordingly.
®
3
AFS 224 User Manual
|
|
|
> |
|
