|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manuale perfetto. Ottimo e utilissimo. Grazie a questo manuale ho potuto realmente risolvere il complesso problema della stampante.
 ;
Was very fast and accurate service. Just what I needed. I recommend to everyone.
;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
INC
Making of self-made tool
the main PCB of repair parts. The making procedure is shown below. Make a self-made tool according to this procedure. This tool is the same one that was made for AF-S24-85/3.5-4. Use the same main PCB that was used for AF-S24-85/3.5-4G.
JAA78851-R.3617.A
� To inspect and adjust the output waveform of MR encoder, it is necessary to make a self-made tool by using
Use this range. Main PCB
â� Remove the mounted parts/elements (condenser, transistor, IC, etc.) from both sides of PCB, within the range of the left dotted lines . Do not remove the connector.
Connector
� Cut off the PCB along the dotted lines.
� Solder the wires on the PCB pattern at 4 parts as shown left.
GND MR-A
MR-B
VCC (5.0V)
- T2ï½¥ AF-S DX17-55/2.8G -
|
|
|
> |
|
