|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank you for providing this manual and at low cost.
The Philips scope is of excellent quality, longevity and build and had a couple of faults
when it was passed to me. Having the CCT diagrams is a blessing.
I have fixed the problems and also modded the scope to my requirements.
I have built a 24v Li-Ion pack for portable use from old but good laptop batts.
it is working beautifully and I am well pleased. Keep up the good work Guys.
 ;
manual was very helpful in learning how to propery use my washer. I could not find this manual anywhere else.
;
Awesome quality manual. You really saved my bacon with this one. Was looking for some specific information with regards to my "new" vintage VCR that didn't come with the owners manual. This site is truely a goldmine of available manuals. The quality of the scans are top notch.
Thank-you so much for this awesome manual. If you're looking for this Sony SL-HF400 owners manual, this is the one you NEED to buy. Definitely worth the money.
;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
INSTALLATION INSTALLATION
WARNING: Turn off and disconnect the unit before working.
Fig.
1
(1) Remove the grille by sliding it to the left until it stops and then pull it towards you.(fig.1)
Grille
2 1
Fig.1
Next lift and unhook the bottom of the air filter and remove it. (fig.2) Unscrew the screw fixing the front panel to the chassis. Keep the screw as it will be used later.
Air filter
2
1
Front panel
Fig.2
(2) Close the grille firmly, and remove the front panel by pulling the front panel at the lower corners towards you for about 3 cm (1" ). Then lift it up and pull it towards you. (Fig.3)
2
Front panel
1
Fig.3
2
(1) Unscrew the 2 stopper screws at the back of the cabinet. (Fig.4) Unscrew the stopper screw from the angle at the front of the chassis. Slide the angle to the left and remove the angle. (Fig.4) Keep the screw and angle as they will be used later in Step 6. (2) Slide the chassis out from the cabinet by pulling on the hand hold located at the bottom center of the chassis. (Fig.4)
Angle
Cabinet Chassis Fig.4
16
|
|
|
> |
|
