|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The purchased manual is an high-quality scan of the original JVC paper-based Service Manual. The Service Manual includes the Owner´s Manual, so you do not have to buy both of them.
 ;
It paid to find this Service Manual, couldn't find it anywhere else. Exactly what I wanted. Received within 24 hours.
;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
;
Excellent printing quality. A complete and very useful manual with all details.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
INC
INSPECTION OF ENCODER SIGNAL
JAA76251-R.3414.A
� Use an F70(N70) camera body and AF nikkor lens inspection program for F70/N70 to display encoder signal on the computer monitor when making an inspection. Inspection method �Start the AF nikkor lens inspection program for F70/N70 and select "1.READING OF LENS ENCODER SIGNAL". Make inspection according to instructions as shown on the display. �Encoder signals should be as described in the table below when the zoom and distance scale are set to specified positions. � Encodr signal for CPU Version 0.1.1 �MF MODE Zoom ring f = 80mm f = 105mm f = 135mm f = 200mm � (Additioanl)
Distance scale position Infinity position 2.5m Most close distance position 1 72h 2 49h 3 63h 1 72h 2 68h
Encoder signal 3 63h 1 72h 2 41h 3 63h 1 72h 57h 36h 2 6Bh 6Bh 6Bh 3 63h 63h 63h
�AF MODE Zoom ring Distance scale position Infinity position 1 72h 2 49h 3 63h 1 2 f = 80mm f = 105mm f = 135mm f = 200mm
Encoder signal 3 1 2 3 1 2 3
� If encoder signal values are different from those shown in the table, following causes moust be considered.� Distance brush is mounted in the wrong position, distance brush or FPC is defective, encoder patterns on the FPC are contaminated, or the FPC is fixed in the wrong position.
Changed page
��� - L21�AF 80-200/2.8D -
June. 29. 2007
|
|
|
> |
|
