|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great price for the manual and easy to locate on the site and download. I would buy again.
 ;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced. Thanks, I will use you again
;
The service manual when downloaded and printed out was clear and easy to read. The manual is complete with the schematic diagram and technical data. I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
Great manual, great price. I am very pleased with Owner-Manuals.com, quick service, fast communication. Will definitely use this site again.
;
Hello from Germany - thank you very much for the manual for my Sharp "Searcher" - the handling of your internet area is outstanding..Mike
3 Select a program number on the TV which you wish to use as the video viewing channel. Then tune in the TV to the picture from the screen being auto tuned or the screen selected with the I and J buttons of the VCR. � During Auto Tuning, the TV program screen does not appear, and the Auto Tuning screen appears instead.
2
If Auto Tuning stops halfway by turning the VCR off, playback or a power failure: 1 Disconnect the mains lead and then reconnect it. 2 Turn off the VCR and then turn it on. � Auto Tuning commences.
AUTO CHANNEL SET PROCEEDING
AUTO TUNING IS COMPLETED.
In some rare cases after tuning the TV to your VCR, interference may be visible on the picture. To get rid of this interference, you can manually adjust the RF output channel a few channels up and down from the current setting. The procedure is described below. 1 Hold down [MENU] for 5 seconds or more. � The VCR display changes as shown below and the VCR picture on the TV displays this pattern.
END
: MENU
END: MENU
To Cancel Auto Tuning MidOperation
Press [MENU] during Auto Tuning. Auto Tuning is cancelled.
To Restart Plug in Auto Tuning
1 Press [EJECT] and remove the video cassette.
Panasonic VCR
2 Keep the I and J buttons on the VCR pressed simultaneously for 3 seconds or more during the VCR on. � The channel displayed on the VCR display disappears for a moment then changes to 2.
END: MENU
2 Enter the desired channel number (US3 or US4) by the I and J buttons. 3()4 3 Press [MENU] to finish the setting mode.
Disappears
2
3 Disconnect the mains lead and then reconnect it. 4 Turn off the VCR and then turn it on. Press [VCR/TV] to select the VCR mode. � Auto Tuning commences.
4 Retune your TV to the new RF channel for the VCR. Note: � Even if the RF output channel has been changed, it is not necessary to perform Auto Tuning.
13
Setting Up
To Change the RF Output Channel
|
|
|
> |
|
