|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
6-4. Video VCO Adjustment
1) Connect the Frequency counter to �VCO� on the VFK1308P. 2) Adjust the VCO frequency to become 41.85MHz±200KHz.
7-7. White Balance Adjustment
1) Set the Lens Cap on front of the Lens. 2) Connect the Video out to the monitor TV. 3) Compare the white level between the EVF and the Monitor TV. If there is a big difference so that white level (Phase) becomes almost same.
6-5. PG Shifter Adjustment
1) Insert the Color Bar Alignment tape (VFM3010EDS) into the Unit. 2) Adjustment is performed automatically.
6-6. RF.VITERBI Adjustment
1) Insert the self-recorded tape into the Unit. 2) Press TAB Key to start the Automatic adjustment.
7. EVF ADJUSTMENT
7-1. PLL Adjustment (Normal)
1) Connect the oscilloscope to �MON-PLL� on the VFK1308P. 2) Adjust the width (T) to become 1.8±0.1µsec as shown in figure when press the F2 Key.
7-2. PLL Adjustment (Wide)
1) Connect the oscilloscope to �MON-PLL� on the VFK1308P. 2) Adjust the width (T) to become 2.3±0.1µsec as shown in figure when press the F2 Key.
7-3. Pedestal Level Adjustment
1) Connect the oscilloscope to �MON-G� on the VFK1308P. 2) Adjust the pedestal level to become 4.1±0.1V as shown in figure when press the F2 Key.
7-4. Pedestal Level Adjustment
1) Connect the oscilloscope to �MON-G� on the VFK1308P. 2) Adjust level to become 3.4±0.1V as shown in figure when press the F2 Key.
7-5. Gamma Level Adjustment
1) Connect the oscilloscope to �MON-G� on the VFK1308P. 2) Adjust V level to become 2.1±0.1V as shown in figure when press the F2 Key.
7-6. Color Level Adjustment
1) Connect the oscilloscope to �MON-B� on the VFK1308P. 2) Adjust V level to become 0.4±0.1V as shown in figure when press the F2 Key.
EAD-10
|
|
|
> |
|
