|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
VERY GOOD SERVICE.FAST ANS VERY HONEST PRICE .RHAANK HERNAN
 ;
Thanks to this service manual I repaired my old camcorder! The manual perfectly explains how to disassemble the camcorder step by step.
 ;
This manual is very useful because it presents the technical specifications of the cd player, including the manufacturer of the reader, this helps if you need to replace it. It also displays the settings and layout of the circuit.
 ;
Manual was a good representation of service infomation for the EWV404. It worked well for my repair.
 ;
Great quality copy, right what I was looking for, all I need to fix my radio.
Thanks
PC-UM10M
[7] ADJUSTMENTS
Note: The head gap adjustment jig for the AJ-6110 differs from those for the conventional models (such as the AJ-2000, etc.). The jig for the AJ-6110 is marked with "N." 3. With the measuring pin lifted up, slide the adjustment tool to the measuring position.
1. GAP ADJUSTMENT BETWEEN THE PRINT HEAD AND PAPER
A. The adjustment is required in the following cases:
� When the main chassis or the carriage shaft is removed. � When the adjustment lever is moved. 4. Fall the measuring pin to the target platen knob. (The fourth one from the left, and the fourth one from the right.)
B. Necessary tools
Tool Height adjustment jig Calibration jig Parts code UKOG-0010ESZZ UKOG-0011ESZZ
C. Calibration of the adjustment tool
For example, when you drop the adjustment tool or in similar events, it is necessary for you to calibrate the tool. If you handle the tool carefully, it will not be necessary to calibrate the tool in normal use. Do not slide the adjustment tool with the measuring pin down. 5. Turn the adjustment lever to adjust so that the measuring pin is at the specified position in the block. Note: Use a magnifying glass to check the gap.
D. Adjustment tool calibration procedure
1. Set the adjustment tool as shown below.
A
A A adjustment tool calibration jig
adjustment tool
2. Loosen the screw and adjust so that the top of the block meets the edge on the measuring shaft groove. (Set at the upper limit.) Note: Use a magnifying glass to check the gap.
1.5mm
E. Gap adjustment procedure
1. Set the paper select lever to the position of normal paper. 2. Set the adjustment tool to the carriage slide section and the shaft as shown below.
1.7mm
If the top of the block is in the groove width of the measuring pin, the head gap is 1.6 m 0.1mm.
AJ-6110 ADJUSTMENTS
7�1
 $4.99 AJ6110 SHARP Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…  $4.99 AJ-6110 SHARP Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
 |
> |
|