|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
thanks a lot.
without the service manual my handycam was going to the trash.
good job, go on.
bye
 ;
This service manual is a good copy of the original, complete and fully readable. It is really useful to repair my Tv set following its clear instructions.
;
Excellent quality. Easy process to download. No issues or problems at all - was exactly what I was looking for and needed. Great service.
;
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
;
This is a service manual in every sense of the word ( French and German versions of the text are included, as well as English..)
There are explanations of the mechanical and electrical functions, plenty of mechanical drawings, and the needed schematics. The quality of the scanning is excellent - all the component values are clearly legible - and very usefully there are pcb component layouts, so you can find a component on the schematic, and then very quicky pinpoint its physical location on the relevant pcb.
I cannot see how I can give this manual any less than the maximum 5 stars! Great value for money, which will pay for itself immediately. Excellent all round!
1-6. Removal of Cylinder Unit
1. Remove the Mechanism Unit. Refer to item 1-5. 2. Unscrew a screw (A). 3. Unscrew the 2 screws (B) and remove the T1 Guide.
(a) T1Guide Screws (B) Screw (A)
Screws (A)
Connector (B)
4. Disconnect a connector (C) which is connected to the Mech. I/F Board on the Mechanism bottom side. 5. Unscrew the 3 screws (D) which have spring, then remove the Cylinder Unit without touching any Mechanism parts.
Notes: 1. When remove the Power Supply Unit, the connector (a) which is connected to the Mother Board and Power Supply Unit is disconnected. 2. Check the connector has been connected securely.
1-8. Removal of Fan Motor
1. Unscrew the 6 screws (A) and remove the Rear Jack Panel.
Screws (B)
Screws (A)
(a)
Connectors (C)
Screws (D)
2. Disconnect a connector P2 (C) 3. Unscrew the 2 screws (B) and remove the Fan Motor.
1-7. Removal of Power Supply Unit
1. Unscrew the 4 screws (A) and lift-up the Power Supply Unit. 2. Disconnect a connector (B) and remove the Power Supply Unit. Connector P2 (C)
Notes: 1. When remove the Rear Jack Panel, the connector (a) which is connected to the Mother Board and Rear Jack Panel is disconnected. 2. Check the connector has been connected securely. DIS-3
|
|
|
> |
|
