|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Rack Mounting
The unit can be installed in a 19-inch standard rack using the rack-mount adaptors supplied with the unit. We recommend using the slide rails and brackets specified below for the installation. CC3001-99-0191 slide rails and B-308 brackets are made by CHASSIS TRAK. For further details, consult your dealer.
1
Remove the four feet from the unit�s bottom panel. Take care to avoid exposing the unit to vibration or impact.
5
Remove the stoppers of the inner members, and install the unit in the rack. After installation, check that the unit moves smoothly. Keep the temperature in the rack between 5°C (41°F) and 40°C (104°F) Use the rack-mount angular brackets supplied with the unit.
2
Mount the slide rail inner members onto the unit.
The length of the mounting screws is limited. Use the screws (M4a10) provided with the slide rails. If one or more mounting screws are lost or misplaced, use screws less than 10 mm long. Be sure to fully tighten the inner members in the four places on the left and right.
3
Attach the outer members of the slide rails and the brackets to the rack. � Note Check that the height is the same on the left and the right.
4
Attach the rack-mount adaptors supplied with the unit to the unit.
Use the screws provided with the rack-mount adaptors as the mounting screws. Be sure to fully tighten the rack-mount adaptors in the two places on the left and the right sides.
17
|
|
|
> |
|
