|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
 ;
again you did a very good job. It was fast too. Photocopy are really readable and clear
 ;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
 ;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
1-21. T1 Loading Arm Unit Replacement & Adjustment
(Removal) Remove the cylinder Unit. (Refer to item 1-1) Move the T1 Post to loading direction by manual ejecting method until the screw (D) can be removal position as shown in Figure 1-19. 3. Unscrew the 2 screws (A) and (C), then remove the S1 and T1 Post from Loading Rail as shown in Figure 1-19. 4. Unscrew the 2 screws (D) and (E), then remove the Loading Rail as shown in Figure 1-19. 5. Remove the T1 Loading Arm Unit as shown in Figure 1-19. (Installation) 1. Install the T1 Loading Arm Unit follow the removal steps in reverse order, then Phase Adjustment should be performed as follows. (Adjustment) 1. When install the T1 Loading Arm Unit, then the hole (A) should be matched hole (B) as shown in Figure 1-19. 2. After installation, confirm that the S1 and T1 Post moving smoothly on the Loading Rail. 3. Perform the T1 Loading Arm Height Adjustment. (Refer to previous item) 4. After perform the height adjustment, execute the Post Height Pre-Adjustment and Tape pass Adjustment. Note: This replacement should be performed simultaneously, replacement of Cylinder Unit. It is convenience for Replacement of T1 Loading Arm Unit. Figure 1-21 1. 2.
1-22. M-Cassette Brake Base Unit Replacement (Camera Recorder only)
(Removal) 1. Disconnect the all connectors on Servo P.C.Board. Unscrew the 4 screws (A) to remove the Servo P.C.Board as shown in Figure 1-22. 2. Unscrew the screw (A) to remove the Cassette Down Photo Unit. 3. Unscrew the screw (B) to remove the MLock/Release Piece Unit. 4. Unscrew the 2 screws (C) to remove the M cassette Brake Base Unit. Then pick up the pin of Eject Arm Unit. (Installation) 1. Install the new cassette Brake Base Unit according to the opposite procedures to
removing. Figure 1-22
3-18
|
|
 |
> |
|