|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
 ;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
;
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
CONTENTS
Rack mounting
The unit can be mounted into a 19-inch standard rack using the optional rack-mounting adaptors (AJMA75P). For the installation rails, it is recommended that the 18-inch rail and bracket (model number CC3061-99-0400) by Chassis Trak be used. (The complete slide rail and bracket unit is not available from Panasonic.) For further details, consult your dealer.
4 Attach the AJ-MA75P rack mount adapter using
the same 4 screws.
1 Attach the inner members of the slide rails.
Refer to the figure below for the locations where the screws are to be attached.
Locations where the screws are secured on the right (R) side of the inner members of the slide rails Rack-mounting adaptors
5 Remove the 4 rubber legs from the bottom of the
unit, and install the unit in the rack. After the unit has been installed, check that it moves smoothly along the rails.
A B C D E F G H
Standard rack
Inner member
<Notes> O The length of the screws used is subject to restriction. (B, G: 10 mm, E: 6 mm) O Attach the inner members at the same symmetrical positions on the left (L) side. O Fix the members in place using 3 screws on each side (total: 6 screws). O The letters �A� to �H� are not actually marked on the side panels.
Fasten it to the rack with set screws.
2 Attach the outer member brackets to the rack.
Check that the height is the same for the left and right brackets.
3 Remove the four screws at the front for attaching
the left and right side panels.
<Notes> O Keep the temperature inside the rack to between 5°C and 40°C. O Bolt the rack securely to the floor so that it will not topple over when the VTR is drawn out.
61 (E)
|
|
|
> |
|
