|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Time code/user bit
Setting the external time code Reproducing the time code/user bit
1 Set the VTR to stop mode. 2 Select �TC� using the COUNTER button.
selection)
1 Set the VTR to stop mode. 2 Select �TC� or �UB� using the COUNTER button.
Playback starts and the time code is shown on the display. When the SUPER switch is set to ON, the time code value is superimposed on the video signals from the VIDEO OUT 3 connector. <Notes> O By installing the SDI board (AJ-YA755G, available as an optional accessory) in the VTR, the time code value is also superimposed onto the video signals which are output from the SDI OUT 3 connector. O When the time code signal cannot be read, the time code is automatically interpolated by the CTL signal. The display appears as shown below. T2R 00:01:04:072
3 Set the TCG switch to EXT. (External time code 3 Press the PLAY button. 4 The following settings can be selected with setup
menu No. 505 (EXT TC SEL). LTC: The LTC signal input to the TIME CODE IN connector (XLR) on the rear panel is recorded as TC. <Note> LTC must be synchronized with the video signal. VITC: The VITC of the input video signal is recorded as TC.
When the time code signal cannot be read, an asterix (2) is displayed.
� �: 1, 3 field �2�: 2, 4 field The colon between the seconds and frames changes to a period during drop frame mode.
55
|
|
|
> |
|
