|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
;
The purchased manual is an high-quality scan of the original JVC paper-based Owner´s Manual. I am very satisfied!
;
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
 ;
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
;
thanks for this download i got a pioneer bdp-lx70a blu-ray player and it had no manual i search everywhere on the internet and came across owner-manuals.com and i found that it was so easy to find and downloaded from this site if i ever need a manual again this would be the first place that i would come too thanks guys
AJ-YA903G Installation Guide-1 CAUTION:
ENGLISH
VORSICHT:
DEUTSCH
Diese Wartungsanleitung ist nur für qualifiziertes Watungspesonal vorgesehen. Um die Gehahr eines elektrischen Schlags zu reduzieren, sollten Sie keine anderen Wartungsarbeiten au�er den in der Bediennungsanleitung beschriebenen durchführen, wenn Sie dazu nicht qualifiziert sind.
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire or electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.
1 Remove the 4 screws on the right side of the AJ-SDX900 (as
seen from the front) and take off the operation panel.
4 Pull the clamps apart while inserting the AJ-YA903G.
Ensure that the board is fully inserted and secured with the clamps.
1 Die 4 Schrauben auf der rechten Seite des AJ-SDX900 (von
vorn gesehen) entfernen, und die Bedienungstafel abnehmen.
4 Die Klemmen beim Einsetzen der AJ-YA903G nach au�en
ziehen. Sicherstellen, dass die Karte einwandfrei sitzt und mit den Klemmen gesichert wird.
Safety cord Sicherheitsschnur
Screws (a4) a
Schrauben (a4)
5 Perform steps 1 and 2 in reverse, and replace the circuit 2 Disconnect the 3 cables, then remove the 4 screws and circuit
board, as shown in the diagram below. board and the operation panel. Take care not to catch the safety cord when replacing the operation panel.
2 Die 3 Kabel abtrennen, dann die 4 Schrauben herausdrehen
und die Platine entfernen, wie in der nachstehenden Abbildung gezeigt.
5 Die Schritte 1 und 2 in umgekehrter Reihenfolge ausführen,
um Platine und Bedienungstafel wieder anzubringen. Achten Sie beim Wiederanbringen der Bedienungstafel darauf, dass Sie die Sicherheitsschnur nicht einklemmen.
Circuit board
Platine
Cables (a3) a Kabel (a3)
Screws (a4) a Schrauben (a4)
3 After removing the circuit board, insert the AJ-YA903G into
the camera as shown in the diagram below.
3 Nach dem Entfernen der Platine die Karte AJ-YA903G in die
Kamera einsetzen, wie in der nachstehenden Abbildung gezeigt.
|
|
|
> |
|
