|
Who's Online
There currently are 5428 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very pleased with the quality of the scan. No complaints whatsoever.
;
I liked the product. I would use their sevices again.
;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
ADJUSTMENTS
4-5. CDP MODE TEST & ADJUSTMENT METHOD
Definition of Mechanical Mode
No
1
MODE
STOP MODE
DEFINITION & STATUS
- Disc haven�t been inserted or disc have been ejected. When disc shall be transported into the unit Mechanism shall be fixed at this mode. - Loading device can insert disc thru the slot. - Floating device being locked. - Disc have been inserted thru the slot in front of unit. It is transient state between STOP mode and PLAY mode. - If disc should be inserted at the state of POWER ON, disc shall be loaded by a series of operation of specified device. - Disc shall be played. - Floating device being unlocked.
2
LOADING MODE
3
PLAY MODE - After disc have being clamped on the turn-table, disc shall be rotated.
4
EJECT MODE
- Disc is to be ejected at this mode. It is transient state between PLAY mode and STOP mode. - If disc should be mounted at the state of POWER ON and commanded by EJECT key, disc shall be ejected thru the slot by a series of operation of specified device.
Standard values / Play-ability test
No ITEMS SPECIFIED VALUES, CONDITIONS STANDARD VALUES RELIABILITY LIMITS
1 2 Loading Time Ejecting Time 7sec + 3sec < 5 sec < 17 sec < 15 sec From insertion up to make sound. (TCD-784) From track No.1 Between the EJECT command and the disc eject completion. (TCD-784) From out-most Track, Between the PLAY command of in-most Track and marking sound. Shall be measure when the center of Disc is correspond with the center of Roller. Shall be measure when the center of Disc is correspond with the center of Roller.
TEST CONDITIONS, REFERENCES
CONNEC TION Fig.6 Fig.6
3
Access Time
6sec + 3sec
< 15 sec
Fig.6
4
Disc Take-up Force
> 120g > 120g
> 90g During play in low temp. > 70g During play in low temp. > 130g
Fig.6
5
Disc
> 80g
Fig.6
6 7
Clamping Force Mechanical Noise
> 130g Loading
Fig.6 Fig.6
Eject -Test should be performed in no reverberation If anything is not < 75dB(A) error, shall not room at the noise level of less than 20dB(A). Play < 40dB(A) -Test should be performed at the 50cm in front defined. Access < 70dB(A) of the unit. -IHF-A MODE (RMS-FAST)(TCD-792D) 12
|
|
|
> |
|