|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
54332-gb.fm5 Page 53 Monday, September 17, 2001 3:11 PM
INSTALLATION
Cooktop
� The cooktop must be set into a worktop between 20 mm and 50 mm thick. There must be nothing between the cooktop and the oven (cross rails, brackets, etc.). If the cooktop is to be installed next to a column unit, leave a distance of at least 100 mm from the edge of the cooktop to the side of the column unit. Cut an opening in the worktop of the dimensions shown in the Product Description Sheet supplied separately. If not already present, fit the supplied seal to the cooktop flange after cleaning the contact area as shown in the figure. If the worktop is made of wood, fit the supplied clips.
�
�
�
Cooktop with electric hotplates
�
1. Position the 4 spring clips (B) and fit them in their locations on the underside of the cooktop. 2. Fit the cooktop into the worktop. � If the worktop is made of marble, plastic, ceramics, natural stone, etc., the cooktop must be secured with brackets (C) code 4819 310 18528 (to be requested from After Sales Service). 1. Position the brackets over the holes and secure them with the supplied screws. 2. Fit the cooktop into the worktop.
Glass-ceramic cooktop
N.B.: Remove the protective film before installing the cooktop. � If the worktop is made of wood, use the supplied spring clips and screws. 1. Position the 4 clips (D) as shown and at the specified dimensions. 2. Secure the clips using screws (E). 3. Fit the cooktop into the worktop. � If the worktop is made of marble, plastic, ceramics, natural stone, etc., the cooktop must be secured with brackets (F) code 4819 404 78697 (to be requested from After Sales Service). 1. Fit the cooktop into the worktop. 2. Position the 4 brackets (F) as shown in the figure, in accordance with the thickness of the worktop. 3. Fix the 4 screws (G) in holes (H).
53
|
|
|
> |
|
