|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
8) Move the carriage to the position indicated on the figure. 9) Loosen the screw which is fixing the tension plate. 10) Move the tension plate in the arrow direction to release the tension, and remove the belt.
C. Assembly procedure
CCD core 1) Pass the core through the CCD-MCU harness. 2) Insert the CCD-MCU harness into the CCD PWB connector of the carriage unit.
3)
2)
4)
3) Move the core which was passed through the CCD-MCU harness near the CCD PWB connector as shown in the figure below, and fix it with a filament tape (19mm wide, 40mm long). For the attachment reference, refer to the figure below. Clean and remove oil from the attachment section. 4) Attach the CCD-MCU harness to the duplex tape on the back of the carriage unit. 5) Attach the PWB holder to the position specified in the figure below. 6) Pass the core through the FFC and the PWB holder, and fix the core.
1)
Note: Attach the FFC to the base plate securely with duplex tape to prevent against coming loose.
11) Remove the screw, and remove the rod stopper. 12) Remove the rod.
3)
2) 1) Note: Attach the FFC to fit with the marking line.
13) Lift the rear side of the carriage, remove the belt and the connector, and remove the carriage.
Marking line
4)
1)
2)
3)
AL-1555 DISASSEMBLY AND ASSEMBLY 8 - 4
 $4.99 AL1255 SHARP
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…  $4.99 AL-1255 SHARP
Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|
