|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Ordered service manuel for a hard to find plasma tv - your company made it easy to find and purchase - I will use you again
Thanks for your help
 ;
This is a high quality manual with clear schematic and components layout diagrams ; with service procedure included.
;
This service manual for the Kenwood KT-990D was reproduced really well ,is very legible and manual is complete.Combined with the low price paid,in the future,I will be checking Owner-Manuals.com any time I need a manual.
;
When I purchased this manual I had my doubts regarding the quality as the price was so reasonable as compared to other outlets.
The manual itself is of high standard the print is very clear as are the diagrams. Obviously with the diagrams one has to zoom in otherwise it is to small to be able to read.
Overall I am very pleased with the company who delivered as they said and with the manual they supplied.
I occasionally require a manual and now having registered with this company I shall order from them in the future.
;
I was at first dubious about payiong for downloaded manuals but having done so, I was extremely impressed with quality of the two manual I ordered, well worth the small price I paid.
I would highly recommend these to my friends.
2. Adjustment Procedure (1) How to activate adjustment mode Turn ON the power (set 1.30V batteries terminal) while shorting TEST of the main circuit board. Once adjustment mode is activated, LCD will all light up and EL backlight will be turned ON. Then it displays �Manufacture MODE�.
(2) Using the multimeter, measure the DC voltage between VDD-GND of the test point. Check that the voltage between VDD-GND is more than 2.3V. If it has not reached 2.3V, short the VO ADJ. of the test point with the solder. (3) EEPROM Initialization Press the �DISPLAY� key. �EP INT OK� appears on the display. Press �PLAY/STOP� key to display �IDLE�.
(4) PIT disc (TEST DISC: TGYS1 or TDYS-1) Press �F-SKIP� and �B-SKIP� keys to shift the pick-up towards the centre. Insert the disc and press �PLAY/STOP� key. (Make sure the top panel is upward) LCD of the remote controller will be displayed �AUTO ADJ H� first, then �COMPLETE�. Press �PLAY/STOP� key again to display �IDLE�. * If it displayed �Failed� during adjustment, it means that some abnormalities are detected and the operation is terminated. (5) GRV disc (SONY MDW-74) Insert the disc and press �PLAY� key. (Check the facing direction of the set) LCD of the remote controller will be displayed �AUTO ADJ L� first, then �COMPLETE�. Press �PLAY/STOP� key again to display �IDLE�. * If it displayed �Failed� during adjustment, it means that some abnormalities are detected and the operation is terminated. (6) Checking RF Level and Error Rate TEST DISC: Insert TGYS1 or TDYS-1. Press ��� key, display �032c 00e� and playback. Make sure if the error rate is below �50e�. Check the RF waveform (TP3) with an oscilloscope and it is within the 1.0±0.2V p-p. Press �PLAY/STOP� key to display �IDLE�. Press �+� key of the remote controller. Display �600c 00e� and playback. Make sure if the error rate is below �60e�.
� 29 �
|
|
|
> |
|
