|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Troubleshooting
Note � Do not close the front cover removing the photoconductor unit. Otherwise, you cannot replace the photoconductor unit because the photoconductor unit holder will be closed. If you do this by mistake, return the
I Hold the inset grips (green part)
of the new photoconductor unit, and push the photoconductor unit to its original position.
J Fix the photoconductor unit with
fastening the screws using the screw driver.
photoconductor unit holder to its original position before replacing the photoconductor unit.
K Close the front cover.
Make sure that the front cover close properly.
L Turn
on the printer�s power switch.
TFWX300E
Replacing the Fuser Oil Bottle and Ozone Filter
Replace the oil bottle and ozone filter whenever the message shown below appears on the panel display.
6
H Hold the inset grips (green part)
of the new photoconductor unit, and insert the photoconductor unit into the photoconductor unit holder. When inserting the photoconductor unit, be careful not to damage the surface of it.
IPDL-C Add FuserOil Add FuserOil
There is the fuser oil bottle and the ozone filter in the Fuser Oil Type305.
R WARNING: � Do not incinerate the oil bottle.
TFWX305E
Note � The white powder on the photoconductor unit is to protect it after installation into the printer. This white powder does not have any adverse effect on the interior of the printer.
This action could cause a fire or getting burned. � Spilt oil is very slippery. If oil is spilt, wipe it with alkaline cleaner. Otherwise, the oily surfaces can create the danger of slipping and personal injury.
90
|
|
|
> |
|
