SHARP AR207
Owner's Manual

COPYING FROM THE ORIGINAL TABLE

5

Place the second original face down on the original table and press the START key again to copy onto the other side.
q q

To stop a copy run during duplex copying, press the CLEAR ( ) key. If an uneven number of originals is set, press the ORIGINAL TO COPY key at the end of the copy run to output the last copy. q To cancel the duplex mode, press the ORIGINAL TO COPY key repeatedly until the indicators in the ORIGINAL TO COPY section all go out. q The image of every front side can be rotated 180° using the image rotation feature. This feature is useful when the originals and copies are in the landscape (horizontal) orientation and the two-sided copies are to be read by turning them left to right rather than top to bottom. To set this feature, follow the procedure below. This feature can also be set using user program No. 20.

MAKING COPIES Copying from the original table

Setting image rotation in duplex copying

1

Press and hold down the ORIGINAL TO COPY key for approximately 5 seconds until the indicator will blink and the currently selected parameter number will blink in the copy quantity display.

2

Select the desired parameter using the numeric keys.
q

0: OFF 1: ON The factory default setting is 0.

3

Press the START key.
q

The selected parameter will be steadily lit.

4

Press the ORIGINAL TO COPY key.
q

The

indicator will stop blinking.

The image rotation in duplex copying can be also set using user program No. 20. See page 51.

22