|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
;
A site where discontinualed schematic diagrams and back dated information can be found on discontinued radios tv's and any electronic equipment can be found. Newer manuals either Service and operating manuals. Radio amateurs should find this site a great source for ham radio equipment manuals. I will return to this site should I need information on any electrical equipment. priced easy to download in a PDF format and print pages need to undertake the repair.
;
Quality scan of the original. All the detail necessary to troubleshoot, repair and adjust the unit. I'm sure I will be downloading more manuals in the future as the need arises.
;
Exactly as described, a Service Manual complete with the schematics and PCB layout delivered in a timely manner. Many thanks for the great service.
 ;
some of the writing is a bit blur but the part in the schmatic was great and i have fixed the machine thanks
(2) Copy lamp
1 Remove the right and left document guides and remove the table
glass.
How to stretch the mirror base wire (Check the following in advance.) Check the wire winding pulley stopping position. Check the wire winding pulleys (front/rear) have a wire groove in the same position. (Visual checks) If the two wire grooves are much different in their level, loosen two set screws securing the pulleys and align the position of the two wire winding pulleys (front/rear). Tighten the two set screws securing the pulleys.
2 Displace the copy lamp unit to the notched part at the rear of the
upper cabinet.
3 Remove the copy lamp.
1 Hook the mirror base wire holder on the optical base hook. 2 Apply the mirror base B against the mirror base positioning plate.
Pass the front and rear mirror base wires through the outside grooves in the mirror base B pulley.
3 Pass the mirror base wires through the grooves in the paper feed
pulley.
4 Pass the mirror base wires under the mirror base B and wind them
on the winding pulleys. At this time, secure the wire groove of each winding pulley at its upper position. Wind the mirror base wires 9 turns, with the 8th wind settled into the groove.
Note: When reinstalling the copy lamp, use caution not to have the wrong direction.
(Rear)
(Front)
F
R
The 1st wind of the mirror base wires should be 9 � 10 mm away from the pulley groove toward the frame side. The copy lamp should be reinstalled as shown above, so that the copy lamp projection is located close to the R side.
5 Pass the mirror base wires through the groove in the paper exit
pulley.
6 Pass the mirror base wires through the inner groove in the mirror
(3) 2nd and 3rd mirror base unit
1 Remove the right and left document guides and remove the table
glass.
base B pulley.
7 Pass the mirror base wire through the wire guide. 8 Hook the mirror base wire tension spring on the slot in the optical
base.
2 Remove the mirror base wire from the 2nd and 3rd mirror base
unit.
3 Move the 2nd and 3rd mirror base unit to the square hole in the
optical base and twist it to remove.
7 � 12
 $4.99 AR5132 SHARP
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
