|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
(6-5)
Open the "Port setup" tab, and enter "115200" in the column of bit/sec. If the above communication speed cannot be set, select and set one of the following speeds. 9600/19200/38600/57600
10) Select the communication speed on the option menu. (Set the communication speed same as what is set in procedures 6) and 7).)
11) Select the data file to be copied (written) to the Flash ROM installed to the Write socket on the ICU MAIN PWB in procedure 1). (11-1) Double-click the "Simulation Command List " holder. 7) Set the communication speed on the machine side. The set value of communication speed on the computer side must be the same as that on the machine side. (7-1) Enter the simulation 49-2 mode.
(11-2) Double-click the "Special" holder. (11-3) Double-click the "Program Download" file. (11-4) The message of "Program Download OK ?" is displayed. Press the OK button. (7-2) Press the key of the same communication speed as what is set in procedure 8). (The set communication speed is highlighted.) Cancel the simulation 49-2. (11-5) Select the data (PWB name) to be written and click the START button.
(7-3)
8) Enter the simulation mode 49-1 mode, and press the ENTER key. (The machine enters the download (Flash ROM writing) mode.)
(11-6) Select the data file to be written, and click the "Open" button. 9) Start the download program on the computer side. (Double-click the Mainte.exe file.)
With the above procedure, downloading (writing to the Flash ROM) is started. (NOTE) Selection of data files to be written determines whether a source ROM (which includes the latest version program and the Flash ROM copy program) or a ROM which has only the latest version program is made. AR-C260/C260M ROM VERSION UP 12 - 8
 $4.99 ARC260 SHARP
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
