|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
2. Put the copier on the desk.
Hold the four knobs of the copier, fit the four tabs of the copier with the four holes of the desk, and place the copier on the desk.
4. Connect the copier and the desk.
Open the desk front cover. Install the connecting plate large to the connecting plate installing position with the four connecting plate fixing screws to fix the copier and the desk. Then cut off the notch sections (at right and left of the copier) in the connecting plate installing section. Install the connecting plate small to the position shown in the figure below with the connecting plate fixing screws (2 pcs. for each) to fix the copier and the desk.
Notch
Fixing screw
Connecting plate small
Notch
3. Remove the lower tray of the copier.
Remove the lower tray of the copier as shown.
Front cover Connecting plate small Fixing screw
Fixing screw
Connecting plate large
5. Install the lower tray of the copier.
Install the lower tray of the copier as shown.
6. Fix the desk to the floor.
Turn the nut of the adjuster which is in the lower section of the desk with a wrench or nippers in the direction of arrow, and adjust and fix the desk on the floor.
Nut Adjuster
3�2
|
|
|
> |
|
