|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
2. Put the copier on the desk.
Hold the four knobs of the copier, fit the four tabs of the copier with the four holes of the desk, and place the copier on the desk.
4. Connect the copier and the desk.
Open the desk front cover. Install the connecting plate large to the connecting plate installing position with the four connecting plate fixing screws to fix the copier and the desk. Then cut off the notch sections (at right and left of the copier) in the connecting plate installing section. Install the connecting plate small to the position shown in the figure below with the connecting plate fixing screws (2 pcs. for each) to fix the copier and the desk.
Notch
Fixing screw
Connecting plate small
Notch
3. Remove the lower tray of the copier.
Remove the lower tray of the copier as shown.
Front cover Connecting plate small Fixing screw
Fixing screw
Connecting plate large
5. Install the lower tray of the copier.
Install the lower tray of the copier as shown.
6. Fix the desk to the floor.
Turn the nut of the adjuster which is in the lower section of the desk with a wrench or nippers in the direction of arrow, and adjust and fix the desk on the floor.
Nut Adjuster
3�2
|
|
|
> |
|
