|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
AR-SP3 6) Attach the rear cover. G Attach the rear cover to its original position and secure it with the screw (M4 � 12). 9) Remove the paper tray lock for packing. G Remove the paper tray lock for packing that secures the turning plate in the paper tray by rotating it in the direction of the arrow and store it in the specified position.
10) Set the paper tray side guide. G Squeeze the lever of the paper tray side guide to slide the guide to the position for the paper size to be used. 7) Return the copier to the normal orientation. G When returning the copier to the normal orientation, gently return it without giving a shock.
Paper guide (B)
Paper guide (A)
11) Load paper into the paper tray. G When loading paper, do not exceed the maximum height line. 8) Insert the DV cartridge into the copier. G Open the bypass tray, side cover, and front cover, and insert the DV cartridge. Then, close the front cover, side cover, and bypass tray.
3 2
12) Remove the optical locking screw and fusing unit packing lever so that the copier is ready. 13) Insert the power plug into the outlet and turn the main switch to the �ON� position. Then, perform the following procedure. 14) Perform SIM setting. G Execute simulation [3] of [26] and enter [1]. 15) Check the center displacement. G Place an original on the document glass and make a copy using the tray in the copier. Then, make a copy using the tray in the installed optional paper feed unit. If the center of the copy from the optional paper feed unit is displaced from the copy from the tray in the copier, adjust the center referring to the service manual.
1
2�7
|
|
|
> |
|
