|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
;
The best diagram that I used in a long time. Everything was right on te money. It was easy and fast. Iwoiuld but again when I need a service manual.
;
The manual is great help for me, i'm happy to have it,thanks
 ;
Very pleased with manual except that a few more details in the drawings might make the job (not yet done, tut-tut) easier. Should be adequate though. Actually I didn't have to pay for this anyway as I was given credit for another item that wasn't quite complete. Good service, then.
;
Very useful manuals, somewhere graphics not very clear!
2) Remove the rear cabinet of the copier.
Remove the seven screws and remove the cabinet. Remove the connector cover.
6) Attach the cushion (one position).
Remove the cover of the double-sided adhesive tape and paste the cushion taking care not to allow it to extend over the plate edges.
�
If a open/close detection is attached, be careful not to break the actuator.
3) Remove the right cabinet.
Remove the five screws.
7) Attach the SPF glass holder cover.
After attaching the SPF glass holding cover, attach the document glass.
4) Remove the document glass holder (left side) and the document glass.
Remove the two screws and carefully remove the document glass holder (left side) and the document glass. Do not separate the glass and holder.
8) Remove the PWB shield plate.
Remove the six screws.
5) Remove the document glass holder cover (right side).
Remove the two screws.
�2�
|
|
|
> |
|
