|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Happy to find finally a schematic for this amplifier. The schematic is of good quality, the pcb layout is useless: all is black. Never the less, it is very easy to find the components on the board using the schematics.
 ;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
 ;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
 ;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
AR-TR2 10)Install the separator motor unit. 13)Install the front cabinet and the right cabinet of the copier.
�
Insert the separator motor unit into the positioning place and fix it with the screw. At that time, check that the grounding plate is at the position shown in the figure of the frame below.
�
Install the right cabinet to the original position, and fix it with the five screws. Connect the flat cable to the operation panel, and install the front cabinet to the original position. and fix it with the 12 screws. Close the original cover.
14)Install the front cover.
�
11)Connect the connector and store it.
Press the both sides of the front cover inward to bend the cover, and install it to the hinge arm. Close the paper cassette.
�
Connect the separator motor connector with the copier side connector, and store them as shown.
15)Install the developing unit. � Hold the developing unit knob, and insert it slowly until it stops.
12)Install the ATC spacer. � Press the pawl on the right side of the fan to remove the fan. Attach the ATC spacer to the shaft, and fix it to the position shown below so that the clearance comes in front. Return and fix the fan to the original position.
Knob
16)Install the right door of the copier and close the front cover and the tray.
�
Install the right door, then close the tray and the front cover.
Pawl
1�3
|
|
 |
> |
|