I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Text excerpt from page 4 (click to view)
INSTALLATION
POSITION
Place the freezer horizontally on a firm surface, resting on all four wheels. The room should be dry and adequately ventilated. If the room temperature exceeds 25°C, falls below 10°C or the relative humidity exceeds 60%, the appliance will not function as it should. Do not place the freezer close to sources of heat, radiators, chimneys, etc., and do not place the freezer in direct sunlight. If the freezer has been handled standing on end it should be allowed to stand in normal position for about 12 hours before switching it on Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.
ELECTRICAL REQUIREMENTS
Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate, located on the backside of the appliance. WARNING: This appliance must be earthed.
SWITCHING ON
Before switching on, the freezer should be cleaned inside. See under �Maintenance�. WARNING: The enclosed wheels must be fitted before switching on the freezer.Do not use the appliance without the wheels because it may result malfunction. Allow the freezer to run for several hours before placing food inside.
