|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
;
This is a service manual in every sense of the word ( French and German versions of the text are included, as well as English..)
There are explanations of the mechanical and electrical functions, plenty of mechanical drawings, and the needed schematics. The quality of the scanning is excellent - all the component values are clearly legible - and very usefully there are pcb component layouts, so you can find a component on the schematic, and then very quicky pinpoint its physical location on the relevant pcb.
I cannot see how I can give this manual any less than the maximum 5 stars! Great value for money, which will pay for itself immediately. Excellent all round!
;
the manual is great and especially hard to find... thanks for the great service and having a hard to find manuel_
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.50 of store credit for Your review.
;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
AV14BJ8ENS / AV14BM8ENS AV14BJ8EPS / AV14BM8EPS AV14BJ8EES / AV14BM8EES
DISASSEMBLY PROCEDURE
AV14BM8ENS / EPS / EES
REMOVING THE REAR COVER
1. 2. 3. Unplug the power c ord. Remove the 4 screws marked A as shown in the Fig. 2. Withdraw the rear cover toward you.
REMOVING THE MAIN PWB
" Removing the REAR COVER. 1. Slightly raise the both sides of the c hassis by hand and withdraw the MAIN PWB. (If necess ary, take off the wire clamp, connectors etc.)
REMOVING THE FRONT AV JACK PWB
" Removing the REAR COVER. " Remove the MAIN PWB. 1. Remove the 2 screws marked B. 2. Remove the FRONT AV JACK PWB.
REMOVING THE HP JACK BOARD
" Removing the REAR COVER. " Removing the MAIN PWB 1. Remove the 1 screws marked C. 2. Remove the HP JACK PWB.
CHECKING THE PW BOARD
To check the back side of the PW Board. 1) Pull out the PW Board. (Refer to REMOVING THE MAIN PWB). 2) Erect the PW Board vertic ally so that you can easily check the back side of the PW Board. [CAUTION] " When erecting the PW Board, be c areful so that there will be no contacting with other PW Board. " Before turning on power, make sure that the wire connector is properly connec ted. " When conducting a check with power supplied, be sure to c onfirm that the CRT EARTH WIRE (BRAIDED ASS�Y) is connected to the CRT SOCKET PW board.
WIRE CLAMPING AND CABLE TYING
1. 2. Be sure to clamp the wire. Never remove the c able tie used for tying the wires together. Should it be inadvertently removed, be sure to tie the wires with a new c able tie.
8
No.51999
|
|
|
> |
|
