|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
AV-21D81 AV-20N81 AV-16N81 AV-16N81G
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. 2. 3. Unplug the power plug. As shown in figure, remove the
5 screws
marked
and the
2 screws marked
. Withdraw the rear cover toward you.
REMOVING THE PW BOARD
After removing the rear cover. 1. Slightly raise the both sides of the PW BOARD by hand. and remove the PWB stopper marked from the front cabinet. 2. Withdraw the PW BOARD backward. (If necessary, take off the wire clamp, connectors etc.)
REMOVING THE SPEAKER
After removing the rear cover. 1. As shown in figure, remove the 4 screws marked . 2. Follow the same steps when removing the other hand speaker.
CHECKING THE PW BOARD
1. To check the back side of the PW Board. 1) Pull out the PW Board. (Refer to REMOVING THE MAIN PW Board) 2) Erect the PW Board vertically so that you can easily check the back side of the PW Board. [CAUTION] When erecting the PW Board, be careful so that there will be no contacting with other PW Board. Before turning on power, make sure that the CRT earth wire and other connector are properly connected.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire. 2. Never remove the cable tie used for tying the wires together. Should it be inadvertently removed, be sure to tie the wires with a new cable tie.
12
No. 51902
|
|
|
> |
|
