|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good reproduction (copy) of original manual. Didn't have a parts list, but schematic was completely labeled with parts. Complete instructions on how to adjust mechanical functions of the 8-track deck. Well worth having and at a very reasonable cost.
;
It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
;
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
;
It was complete service manual with all needed service informations. Thanks.
 ;
El manual esta muy detallado, los numeros de partes y los esquemas de despiece son correctísimos y muy claros, tanto para los técnicos experimentados como para los novatos.
AV-20420 AV-20421 2.4 DISASSEMBLY PROCEDURE 2.4.1 REMOVING THE REAR COVER (1) Unplug the power plug. (2) Remove the 5 screws [A], and 2 screws [B] as shown in Fig.1. (3) Withdraw the REAR COVER toward you.. CAUTION: When reinstalling the rear cover, carefully push it inward after inserting the MAIN PWB into the rear cover groove. 2.4.4 CHECKING THE MAIN PW BOARD (1) Pull out the MAIN CHASSIS (refer to REMOVING THE MAIN PWB). (2) Erect the chassis vertically so that you can easily check the MAIN PWB from the reverse (solder) side. CAUTION: � When erecting the MAIN PWB, be careful so that there will be no contacting with other PWB. � Before turning power on, make sure that the CRT earth wire and other connectors are properly connected. � When conducting a check with power supplied, be sure to confirm that the CRT EARTH WIRE (BRAIDED ASS�Y) is connected to the CRT SOCKET PWB.
2.4.2 REMOVING THE MAIN PWB � Remove the REAR COVER. (1) Raise the backside of the MAIN PWB slightly. And remove the PWB STOPPER [C] from the cabinet bottom. (2) Withdraw the MAIN PWB backward. (If necessary, remove the wire clamp and connectors, etc.)
2.4.3 REMOVING THE SPEAKER � Remove the MAIN PW board. (1) Remove the 2 screws [D]. (2) Then you can remove the SPEAKER.
2.4.5 WIRE CLAMPING AND CABLE TYING (1) Be sure to clamp the wire. (2) Never remove the cable tie used for tying the wires together. Should it be inadvertently removed, be sure to tie the wires with a new cable tie.
1-6 (No.52111)
|
|
|
> |
|
