|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A great copy of the manual, and the only one I could find anywhere on the net! The circuit diagrams are easily readable, all component values marked and easy to see. A highly appreciated download!
 ;
Great Manual. This manual is available no where else. It was exactly what I was looking for.
;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
AV-21D81 AV-20N81 AV-16N81 AV-16N81G
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. 2. 3. Unplug the power plug. As shown in figure, remove the
5 screws
marked
and the
2 screws marked
. Withdraw the rear cover toward you.
REMOVING THE PW BOARD
After removing the rear cover. 1. Slightly raise the both sides of the PW BOARD by hand. and remove the PWB stopper marked from the front cabinet. 2. Withdraw the PW BOARD backward. (If necessary, take off the wire clamp, connectors etc.)
REMOVING THE SPEAKER
After removing the rear cover. 1. As shown in figure, remove the 4 screws marked . 2. Follow the same steps when removing the other hand speaker.
CHECKING THE PW BOARD
1. To check the back side of the PW Board. 1) Pull out the PW Board. (Refer to REMOVING THE MAIN PW Board) 2) Erect the PW Board vertically so that you can easily check the back side of the PW Board. [CAUTION] When erecting the PW Board, be careful so that there will be no contacting with other PW Board. Before turning on power, make sure that the CRT earth wire and other connector are properly connected.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire. 2. Never remove the cable tie used for tying the wires together. Should it be inadvertently removed, be sure to tie the wires with a new cable tie.
12
No. 51902
|
|
|
> |
|
