|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
AV-21BD5EKI AV-21BD5EP AV-21BD5EE AV-21BD5EKIS AV-21BD5EPS AV-21BD5EES
ADJUSTMENTS
+B VOLTAGE CHECK
1. Receive the standard colour bar signal. 2. Connect digital voltmeter between + of B1 Line circuit and GND. 3. Confirm that voltage is DC 123V # 2.0V.
SCREEN
1. Set TV in AV mode without video signal � Black screen. 2. Set [WP Red], [WP Green] and [WP Blue] equal to �32�. 3. Set [Black R], [Black G] equal to �8�. 4. Set TV in normal I mode. 5. Adjust SCREEN VR (on FBT) such that the highest cathode cut-off voltage measured on CRT SOCKET PWB ASS�Y is DC 125V ± 5V.
WHITE BALANCE
NOTE : Confirm SCREEN Adjustment has been adjusted.
â� LOW LIGHT
1. 2. 3. 4. Input the 10-step gray scale signal. (include10% Black) Enter the SERVICE MODE. Turn the SCREEN VR (on FBT) gradually, to where the 2nd gray bar(10% Black) faintly visible. Adjust [Black B] and [Black R] not to the colours on the gray bar.
â� HIGH LIGHT
5. Apply the white signal. 6. Adjust [R DRIVE] and [G DRIVE] so that the picture becomes white.
FOCUS
1. Input the crosshatch pattern signal. 2. Adjust the FOCUS VR (on FBT) to have the best resolution on screen.
VERTICAL GEOMETRY
Adjust [V Amp], [V Shift] and [V Slope], [V Slope] [V S Cor] to compensate for vertical distortion.
HORIZONTAL PICTURE CENTERING
Adjust [H Shift] to have the picture in the center of the screen.
No.51742
1-11
|
|
|
> |
|
