|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
 ;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
 ;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
 ;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
AV-21BD5EKI AV-21BD5EP AV-21BD5EE AV-21BD5EKIS AV-21BD5EPS AV-21BD5EES
ADJUSTMENTS
+B VOLTAGE CHECK
1. Receive the standard colour bar signal. 2. Connect digital voltmeter between + of B1 Line circuit and GND. 3. Confirm that voltage is DC 123V # 2.0V.
SCREEN
1. Set TV in AV mode without video signal � Black screen. 2. Set [WP Red], [WP Green] and [WP Blue] equal to �32�. 3. Set [Black R], [Black G] equal to �8�. 4. Set TV in normal I mode. 5. Adjust SCREEN VR (on FBT) such that the highest cathode cut-off voltage measured on CRT SOCKET PWB ASS�Y is DC 125V ± 5V.
WHITE BALANCE
NOTE : Confirm SCREEN Adjustment has been adjusted.
â� LOW LIGHT
1. 2. 3. 4. Input the 10-step gray scale signal. (include10% Black) Enter the SERVICE MODE. Turn the SCREEN VR (on FBT) gradually, to where the 2nd gray bar(10% Black) faintly visible. Adjust [Black B] and [Black R] not to the colours on the gray bar.
â� HIGH LIGHT
5. Apply the white signal. 6. Adjust [R DRIVE] and [G DRIVE] so that the picture becomes white.
FOCUS
1. Input the crosshatch pattern signal. 2. Adjust the FOCUS VR (on FBT) to have the best resolution on screen.
VERTICAL GEOMETRY
Adjust [V Amp], [V Shift] and [V Slope], [V Slope] [V S Cor] to compensate for vertical distortion.
HORIZONTAL PICTURE CENTERING
Adjust [H Shift] to have the picture in the center of the screen.
No.51742
1-11
|
|
 |
> |
|