|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good-quality scans. Detailed description. I hope I can repair the machine.
;
High-quality scanning. Detailed description. Recommend for all technician. A+++
;
This is a good quality scan of the original Service Manual from Nordmende, Germany. Contains the circuit diagram, PCB layout, adjust/tune instructions as well. It is NOT in English but in GERMAN language! That was quite right for my german friend from the lower east side in Berlin.
 ;
Received via e-mail this PDF manual is worth the money. This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand. I have later seen the original manual and it was printed in colour, but this particular manual is black & white but scan resolution is high end quality! All drawings and pictures are presented in great detail. So, nearly perfect score in my opinion.
If you own the turntable you also should own the manual!
;
I was very satisfied with the service manual I ordered and downloaded. I will definitely buy again from this seller.
KS-LX200R
Removing the main board assembly (See Fig.6 to 8)
Prior to performing the following procedure, remove the top chassis. 1. Remove the screw S attaching the bracket (L). 2. Disconnect the flexible harness from connector CN701, the card wire from CN702 on the main board and the harness from CN503 and CN504 respectively. 3. Remove the three screws H attaching the main board assembly to the bottom cover on the upper side of the body. 4. Remove the screw I attaching the rear panel and the bottom cover on the back of the body. Move the main board in the direction of the arrow and release the two joints a. (At this point, the main board can be removed with the rear panel and the rear heat sink.) 5. Remove the screw J and the two screws K attaching the rear heat sink on the back of the body. 6. Remove the two screws L and the screw M attaching the rear panel. Now, the main board assembly will be removed. ATTENTION: When reassembling, correctly engage the switch S561 and S562 on the main board with the part e of the operation assembly (Refer to Fig.7, 18 and 19).
Main board S652 S651 CN503 Bracket (L) CN701 Main board assembly CN504
H S H Joint a
Joint a CN702 Front panel assembly
H
Fig.6
e
Fig.7
M L L
Rear heat sink
J
Rear panel
K
I
Fig.8
1-4
|
|
|
> |
|
