|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Superb manual. Exactly what I ordered and made available in a very timely manner.
 ;
very fast detailed and accurate hope to do business again
;
This was precisely what I was looking for. Complete and good quality!
;
This is the ONLY copy of this manual I could find for a realistic price. Even Panasonic could not provide me with one.
The PDF is a very good copy and it helped me diagnose and find the fault with the unit I have.
;
Very complete and well reading drawings. Documentation is essential for successful repairs.Good documentation, with all that is necessary. This manual was what I was waiting with all the information necessary for the repairing I need it for. You must buy it if you want to do repairs or simply understand how it works.
AV-29BF11ENS AV-29BF11EPS AV-29BF11EES
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. Remove the 8 screws marked A. 2. Remove the 4 screws marked B. 3. Withdraw the rear cover toward you.
CHECKING THE PW BOARD
To check the back side of the PW Board. 1) Pull out the PW Board. (Refer to REMOVING THE MAIN PWB). 2) Erect the PW Board vertically so that you can easily check the back side of the PW Board. [CAUTION] " When erecting the PW Board, be careful so that there will be no contacting with other PW Board. " Before turning on power, make sure that the wire connector is properly connected. " When conducting a check with power supplied, be sure to confirm that the CRT EARTH WIRE (BRAIDED ASS�Y) is connected to the CRT SOCKET PW board.
REMOVING THE MAIN PWB
" Removing the rear cover. 1. Slightly raise the both sides of the chassis by hand and withdraw MAIN PWB back ward. [CAUTIONS] If necessary, take off the wire clamp, connectors etc. Be careful enough when developing a main chassis.
REMOVING THE FRONT AV & HEADPHONE BOARD ASS�Y
" Removing the rear cover. " Removing the MAIN PWB. 1. Remove the 2 screws marked C, and remove the FRONT AV & HEADPHONE BOARD ASS�Y.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire. 2. Never remove the cable tie used for tying the wires together. Should it be inadvertently removed, be sure to tie the wires with a new cable tie.
REMOVING THE FRONT CONTROL PWB
" Removing the rear cover. " Removing the MAIN PWB. 1. Remove the 3 screws marked D, and remove the FRONT CONTROL PWB.
REMOVING THE WOOFER and TWEETER
" 1. 2. 3. Removing the rear cover. Remove the 4 screws marked E, and remove the WOOFER. Remove the 2 screws marked F, and remove the TWEETER. Remove an opposite side similarly.
REMOVING THE MAIN SWITCH
" Removing the rear cover. " Removeing MAIN PWB. 1. Remove the 2 screws marked G, and remove the MAIN SWITCH.
6
No.52084
|
|
|
> |
|
