|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
AV-29BH11ENS AV-29BH11EPS AV-29BH11EES
Item BOW adjustment
Measuring instruments Signal generator Remote control unit
Test point
Adjustment part BOW 1. 2. 3. 4. 5. 6. 7.
Description Receive a cross-hatch signal. Enter the SERVICE MENU. Press the RED key on the remote control unit, then enter the H/V adjustment group. Select BOW with the UP/DOWN ( / ) key. Adjust BOW with the LEFT/RIGHT ( / ) key and the vertical line straight. Check and readjust BOW item if the adjustment becomes improper after some other geometric adjustments are done. Press the INFORMATION key and memorize the set value.
NOTE : In case where there is a bow-shaped distortion of images on the screen. (Figure)
TRAPEZIUM adjustment
Signal generator Remote control unit
TRAPEZ
1. 2. 3. 4. 5.
Parallel 6. 7.
Receive a cross-hatch signal. Enter the SERVICE MENU. Press the RED key on the remote control unit, then enter the H/V adjustment group. Select TRAPEZ with the UP/DOWN ( / ) key. Adjust TRAPEZ with the LEFT/RIGHT ( / ) key till vertical lines, especially lines at the sides of the picture frame became parallel to the both sides of picture tube as close as possible. Check and readjust TRPEZ item if the adjustment becomes improper after some other geometric adjustments are done. Press the INFORMATION key and memorize the set value.
No. 52085
15
|
|
|
> |
|
