|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Quality scan of the original. All the detail necessary to troubleshoot, repair and adjust the unit. I'm sure I will be downloading more manuals in the future as the need arises.
;
Exactly as described, a Service Manual complete with the schematics and PCB layout delivered in a timely manner. Many thanks for the great service.
 ;
some of the writing is a bit blur but the part in the schmatic was great and i have fixed the machine thanks
;
Well.. I'd searched for this manual and although I found many copies online I was pleased to find your website with a well balanced pricing system and easy to search and follow links. That together with the very quick response time was just what I was looking for.. being a very impatient tech.. ;-) I had the service manual in front of me within a short time.
Bookmarked.. and you can bet I will always come here first for my service & user manuals..
best regards
Ed(Tony) Foley
G7WHK
;
I will definitely be back for more information when I need it.
AV-32WL1EU AV-32WL1EI AV-32WL1EK
REMOVING THE CRT
Replacement of the CRT should be performed by 2 or more persons. After removing the cover, chassis etc.. 1. Putting the CRT change table on soft cloth, the CRT change table should also be covered with such soft cloth (shown in Fig.5). 2. While keeping the surface of CRT down, mount the TV set on the CRT change table balanced will as shown in Fig.5. 3. Remove 4 screws marked by arrows with a box type screw driver as shown in Fig.6. Since the cabinet will drop when screws have been removed, be sure to support the cabinet with hands. 4. After 4 screws have been removed, put the cabinet slowly on cloth (At this time, be carefully so as not to damage the front surface of the cabinet) shown in Fig.7. The CRT should be assembled according to the opposite sequence of its dismounting steps. The CRT change table should preferably be smaller that the CRT surface, and its height be about 35cm. CLOTH CRT CHANGE TABLE
APPROX. 35cm
Fig. 5 CRT
CRT CHANGE TABLE BOX TYPE SCREW DRIVER
Fig. 6
CRT
COATING OF SILICON GREASE FOR ELECTRICAL INSULATION ON THE CRT ANODE CAP SECTION.
Subsequent to replacement of the CRT and HV transformer or repair of the anode cap, etc. by dismounting them, be sure to coat silicon grease for electrical insulation as shown in Fig.8. Wipe around the anode button with clean and dry cloth. (Fig.8) Coat silicon grease on the section around the anode button. At this time, take care so that any silicon greases dose not stick to the anode button. (Fig.9) � Silicon grease product No. KS - 650N CRT Anode button Approx. 20mm (Do not coat grease on this section Silicon grease should be coated by 5mm or more from the outside diameter of anode cap. Fig. 7 CABINET CRT CHANGE TABLE
Silicon grease coating
Anode button (No sticking of silicon grease)
Coating position of silicon grease
Anode cap
Fig. 8
Fig. 9
12
No. 51733
|
|
|
> |
|
