This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
Text excerpt from page 155 (click to view)
5
6
7
8
- Removing the Display Assy (Fig.7)
Display Assy
Holder
A
1 2 3
Remove the two screws and then remove the Holder. Remove the three screws and then remove the Cover Unit. Remove the four screws.
1
1
4
4
Disconnect the connector and then remove the Display Assy.
4 2 2 2
4
B
Cover Unit
Fig.7 - Removing the Monitor PCB (Fig.8)
1
Straighten the tabs at two locations indicated.
1
1
C
2
Remove the three screws.
Disconnect the connector and then remove the Monitor PCB.
2 2
2
D
Monitor PCB
Fig.8
Note: Tighten the screws with the panel in warped state as shown in the photograph below. Otherwise, it will be difficult to install Detach Grille Assy to Panel Assy.
E