|
There are currently no product reviews.
 ;
I am really satisfied. It was ceap, easy and quick. Te owner manual is a full service book. I got what I expected. Thx
;
The service was good but it just a little late for the download. It seems that it needs to clear the payment but the payment was settled by paypal. As far as my concern, it should be able to download after the confirmation of sold.
;
Great quality manual, fast service, excellent seller... Thanks !!!
;
Great manual and fast service. Download was possible after a few hours.
;
thanks a lot.
without the service manual my handycam was going to the trash.
good job, go on.
bye
CX-961
1) Focus error amplifier unit
This focus error amplifier outputs photodetector output (A + C) or (B + D) from pin 16 of IC201 (TA2150FN) via a differential amplifier and an error amplifier assuming (A + C - B -C) as an FE signal. The low frequency component of voltage FE is expressed as FE = (A + C - B - D) � (150 k / 62 k) � (60 k / 60 k) � (12 k / 60 k) = 4.84 times. An S curve of approximately 1.45 Vpp is obtained in the FE output on the basis of Vref. The cutoff frequency is 26 kHz or 133 kHz.
Fig.2:FE CIRCUIT
2) Tracking error amplifier unit
This tracking error amplifier unit outputs photodetector output E or F from pin 14 of IC201 (TA2150FN)via an amplifier and an error amplifier assuming (E - F) as a TE signal. The low frequency component of voltage TE is expressed as TE = (E - F) � 300 k / 100 k � 155 k / 328 k � 82 k / 20 k = 5.8 times. A TE waveform of approximately 1.51 Vpp is obtained in the TE output on the basis of Vref. The cutoff frequency is 44.5 kHz or 29.4 kHz.
Fig.3:TE CIRCUIT
3
|
