|
There are currently no product reviews.
 ;
Very useful Service Manual! With it I was able to identify the damaged pots in my old amplifier, purchase the adequate replacements and make myself the repair.
I have again my old amplifier, still a very good one that I will keep for as many years as I can!
Thanks to Owner Manuals!
;
Good price for the manual and easy to locate on the site and download. Plus, just like the original. Thanks a lot.
;
Genuine Service Manual. Link was available in less then an hour or so. Service Manual contains assembly, PCB layout, complete circuit diagram, Components list etc
;
Great and very well scanned Service Manual, also very fast download - Recomended !
;
I'm quite impressed. I had to wait 24 hours for my manual (quite a rare one) but I got it and the quality was good. Also, from trawling the web, these prices are by far the best.
CX-961
1) Focus error amplifier unit
This focus error amplifier outputs photodetector output (A + C) or (B + D) from pin 16 of IC201 (TA2150FN) via a differential amplifier and an error amplifier assuming (A + C - B -C) as an FE signal. The low frequency component of voltage FE is expressed as FE = (A + C - B - D) � (150 k / 62 k) � (60 k / 60 k) � (12 k / 60 k) = 4.84 times. An S curve of approximately 1.45 Vpp is obtained in the FE output on the basis of Vref. The cutoff frequency is 26 kHz or 133 kHz.
Fig.2:FE CIRCUIT
2) Tracking error amplifier unit
This tracking error amplifier unit outputs photodetector output E or F from pin 14 of IC201 (TA2150FN)via an amplifier and an error amplifier assuming (E - F) as a TE signal. The low frequency component of voltage TE is expressed as TE = (E - F) � 300 k / 100 k � 155 k / 328 k � 82 k / 20 k = 5.8 times. A TE waveform of approximately 1.51 Vpp is obtained in the TE output on the basis of Vref. The cutoff frequency is 44.5 kHz or 29.4 kHz.
Fig.3:TE CIRCUIT
3
|
