This is exactly what I needed This was a hard one to find and I had already downloaded several for other Panasonic radios but none matched my radio.
Although my radio is the LBE model the LBS is the same.
A very good quality manual with every thing you should get in it
As Always these people were very rapid and efficient. A great job helping hobbiest and workers!!! Thank you a lot!
Text excerpt from page 169 (click to view)
5
6
7
8
- Removing the Case (Fig.5)
A
1 2 3
Remove the two screws and then remove the Holder. Remove the screw.
3 1 3 2 3 1 3
3
Remove the five screws and then remove the Case.
B
Case
Holder
Fig.5
- Removing the Display Assy (Fig.6)
Motor Unit
1
Remove the screw.
Disconnect the connector and then remove the Motor Unit.
Switch
C
1
2 3
Remove the two screws and then remove the two Holders. Pull out the Display Assy in the arrow indicated direction.
Note) When reassembling, hold the switch down with tweezers or the like and put the Display Assy back to the Chassis. Otherwise, the switch may be damaged and not function properly.
D
2
2
Holder
3
Holder Display Assy
Fig.6
- Removing the Main Unit (Fig.7)
Bracket
2 3 1 3 3
Shaft Unit
2
E
1 2 3
Remove the screw and then remove the Bracket. Remove the four screws and then remove the Shaft Unit. Remove the three screws.
2
2
Disconnect the connector and then remove the Main Unit.