|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
;
Great deal, you are the only one on earth who could deliver this old manual. Thx so much and have nice chrismas
Section
13
Audio Adjustments
1 Touch A.MENU and AUDIO and then touch LOUDNESS. 2
# To turn loudness off, touch
Touch
to turn loudness on.
.
3 Touch or to select a desired level. Each time you touch or selects level in the following order: LOW (low)MID (mid)HIGH (high)
5 Touch and then touch or to select cut-off frequency. Each time you touch or selects cut-off frequencies in the following order: 50Hz80Hz125Hz Only frequencies lower than those in the selected range are outputted from the subwoofer.
Using nonfading output Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. ! When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Touch A.MENU and AUDIO and then touch SUB WOOFER.
# When the subwoofer controller setting is FULL, you cannot select SUB WOOFER.
When the nonfading output setting is on, the audio signal does not pass through this units low pass filter (for the subwoofer), but is outputted through the RCA output. 1 Touch A.MENU and AUDIO and then touch NON FADING.
# When the subwoofer controller setting is only FULL, you can select NON FADING. (Refer to page 83.)
2
Touch
to turn non fading output on.
.
2
# To turn subwoofer output off, touch
Touch
to turn subwoofer output on.
.
# To turn non fading output off, touch
3 Touch and then touch or to select the phase of subwoofer output. Touch to select normal phase and NORMAL appears in the display. Touch to select reverse phase and REVERSE appears in the display. 4 Touch and then touch or to adjust the output level of the subwoofer. Each time you touch or increases or decreases the level of the subwoofer. +6 6 is displayed as the level is increased or decreased.
3 Touch or to adjust the output level of the non fading. Each time you touch or increases or decreases the level of the non fading. +6 6 is displayed as the level is increased or decreased.
Using the high pass filter
When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are outputted from the front or rear speakers.
62
En
|
|
|
> |
|
Home
