|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Section
05
Basic Operations
Ejecting a disc
You can specify a holder that you eject a disc from. 1 Press OPEN on the unit to display loading/ejecting menu. The LCD panel opens halfway, and the loading/ejecting menu is displayed on the screen.
! If the disc in the holder has already been played, the disc type is displayed on the holder icon (e.g. CD, DVD etc.). ! NO DISC is displayed for an empty holder.
! The adjusted flap angle will be memorized. The next time you eject or load discs, the flap returns to the position where you set the angle.
Adjusting the volume
% Use VOLUME to adjust the sound level. Press VOLUME to increase or decrease the source volume. With the remote control, press VOLUME to increase or decrease the volume.
2 Touch h next to the holder you want to eject the disc from. The disc is ejected.
# You can eject all loaded discs at once. To do this, touch ALLh. To cancel the all ejecting, touch CANCEL.
Turning the unit off
% When using the touch panel keys, touch the source icon and then touch OFF.
# When the source icon is not displayed, you can display it by touching the screen. # When using the buttons, press SOURCE and hold until the unit turns off. # To completely turn the display off, touch and hold DISP. OFF. Refer to Using the common touch panel keys on the next page.
3 To replace the LCD panel to the original position, press OPEN on the unit.
Adjusting the flap angle
You can adjust the flap angle as needed.
Important When adjusting the flap angle, be sure to follow the procedures explained below. Forcibly adjusting the flap angle by hand may damage it.
1 Press and hold OPEN button on the unit to display the flap angle adjust menu. 2 Touch + or - to adjust the flap angle. Each time you touch +, the flap comes out toward you. Touching - moves the flap the other way around.
! You can select from five positions for the flap angle.
22
En
|
|
|
> |
|
