|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Section
16
Audio Adjustments
Note If you make adjustments, Custom curve is updated.
select reverse phase and REVERSE appears in the display. 4 Touch c or d on the LEVEL setting to adjust the output level of the subwoofer. Each time you touch c or d increases or decreases the level of the subwoofer. +6 to �6 is displayed as the level is increased or decreased. 5 Touch c or d on the FREQUENCY setting to select cut-off frequency. Each time you touch c or d selects cut-off frequencies in the following order: 50Hz�80Hz�125Hz Only frequencies lower than those in the selected range are outputted from the subwoofer.
Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Touch LOUDNESS on the audio function menu. 2 Touch c on the LOUDNESS setting to turn loudness on.
# To turn loudness off, touch d.
3
Touch c or d on the MODE setting to
select a desired level. Each time you touch c or d selects level in the following order: LOW (low)�MID (mid)�HIGH (high)
Using nonfading output
When the nonfading output setting is on, the audio signal does not pass through this unit�s low pass filter (for the subwoofer), but is outputted through the RCA output. 1 Touch NON FADING on the audio function menu.
# When the PREOUT setting in the initial menu is only FULL, you can select NON FADING. (Refer to page 94.)
Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. ! When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Touch SUB WOOFER on the audio function menu.
# When the PREOUT setting in the initial menu is FULL, you cannot select SUB WOOFER.
2 Touch c on the NON FADING setting to turn non fading output on.
# To turn non fading output off, touch d.
2 Touch c on the SUBWOOFER setting to turn subwoofer output on.
# To turn subwoofer output off, touch d.
3
Touch c or d on the PHASE setting to
select the phase of subwoofer output. Touch d to select normal phase and NORMAL appears in the display. Touch c to
3 Touch c or d on the LEVEL setting to adjust the output level of the non fading. Each time you touch c or d increases or decreases the level of the non fading. +6 to �6 is displayed as the level is increased or decreased.
72
En
|
|
|
> |
|
