|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Section
17
Audio Adjustments
When front speaker HPF is selected in the network mode
Parameter What it does Selects cut-off frequencies in the following order: 50�63�80�100�125�160� 200 (Hz) Selects slopes in the following order: �18� �12� �6 (dB/oct.)
eration, refer to Storing the adjusted audio settings in memory on page 93.
FREQUENCY
Using the time alignment
The time alignment lets you adjust the distance between each speaker and the listening position.
SLOPE
To switch the filter of the front speaker between LPF and HPF, touch HIGH PASS or LOW PASS.
When front speaker LPF is selected in the network mode
Parameter What it does Selects cut-off frequencies in the following order: 1.25k�1.6k�2k�2.5k�3.15k� 4k�5k�6.3k�8k�10k�12.5k (Hz) Selects slopes in the following order: �12� �6�0 (pass) (dB/oct.)
Recalling time alignment settings
% Touch TIME ALIGNMENT on the sound setting menu to select the time alignment. Touch TIME ALIGNMENT repeatedly to switch between the following time alignment settings: INITIAL�AUTO�CUSTOM1�CUSTOM2� CUSTOM3�LAST MEMORY�OFF
# You can select LAST MEMORY only when the adjusted time alignment setting is not memorized in this unit. # You cannot select AUTO when NETWORK has been selected. (Refer to Switching the DSP setting mode on page 105.) # When STANDARD has been selected, you cannot select AUTO if auto TA and EQ has not been carried out.
FREQUENCY
SLOPE
# You can mute the selected speaker unit by touching MUTE OFF. To cancel muting, touch MUTE ON. Notes ! Selecting cut-off frequencies sets cut-off frequencies of the subwoofer�s L.P.F. (low-pass filter) and that of the SMALL speaker H.P.F. (high-pass filter). The cut-off frequency setting has no effect if the subwoofer is set to OFF and other speakers are set to LARGE or OFF. ! If trying to boost the bass output of the subwoofer doesn�t do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofer�s output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer. ! You can store the adjusted setting in memory by using MEMORY. For details concerning op-
Adjusting the time alignment
You can adjust the distance between each speaker and the selected position. ! An adjusted time alignment can be memorized in CUSTOM1, CUSTOM2 or CUSTOM3. 1 Recall the time alignment setting you want to adjust. Refer to Recalling time alignment settings on this page.
90
En
|
|
|
> |
|
