|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
1
2
3
4
- Removing the Case (Fig.5)
A
1 2 3
Remove the two screws and then remove the Holder. Remove the screw.
3 1 3 2 1 3
3
3
Remove the five screws and then remove the Case.
B
Case
Holder
Fig.5
- Removing the Display Assy (Fig.6)
Motor Unit
Switch
1
Remove the screw.
Disconnect the connector and then remove the Motor Unit.
1
C
2 3
Remove the two screws and then remove the two Holders. Pull out the Display Assy in the arrow indicated direction.
Note) When reassembling, hold the switch down with tweezers or the like and put the Display Assy back to the Chassis. Otherwise, the switch may be damaged and not function properly.
2
D
2
Holder
3
Display Assy Holder
Fig.6
- Removing the Main Unit (Fig.7)
Bracket
2 1 3 3
Shaft Unit
2
1
E
Remove the screw and then remove the Bracket. Remove the four screws and then remove the Shaft Unit.
2 3
2
2
Remove the three screws.
3
Disconnect the connector and then remove the Main Unit.
Main Unit
Fig.7
F
264
1 2
AVIC-N1/UC
3 4
|
|
|
> |
|
